Draw the circuit diagram of Half wave rectifier.
[3 marks]Explain the bridge rectifier with diagrams.
[4 marks]Determine the Vo for the network shown in figure 1 Figure 1
[7 marks]Explain Varactor diode and varistor.
[3 marks]Why Zener diode can be used as voltage regulator? Explain Zener as voltage regulator with necessary diagram
[4 marks]Compare the logic families and explain any one of them.
[7 marks]Explain Ex-OR and Ex- NOR gate with truth table and construct OR gate using diodes.
[7 marks]Explain about DC load line and Bias point of transistor
[3 marks]Explain the working of PIN Diode.
[4 marks]Briefly explain the h-parameters and draw h-parameter based equivalent circuit for CE transistor and derive equation for input impedance, output impedance and voltage gain.
[7 marks]Write truth table of AND, NAND and NOR gates.
[3 marks]Explain the selection of a Qpoint for a transistor bias circuit and discuss the limitations on the output voltage swing.
[4 marks]Explain the difference between clipping and clamping circuit. Apositive voltage clamping circuit and a positive voltage clipping circuit each have ±12 Vsquare Wave input. Sketch the output waveform for each circuit.
[7 marks]Draw voltage multiplier circuit.
[3 marks]Explain Transconductance and switching in FET.1
[4 marks]Explain the Depletion region and drain characteristics of n channel JFET.
[7 marks]Discuss about VI characteristic of Ideal Diode.
[3 marks]Explain FET as an Amplifier.
[4 marks]Determine the voltage Vo for the network of Figure 2. Give explanation for your answer. Figure
[2 marks]Explain the working of Transistor as Switch
[3 marks]Write a short note on E MOSFET as an Amplifier.
[4 marks]Design a series noise clipping circuit which rectify the noise signal with amplitude lower than ±V . F
[7 marks]Explain the AC load line of transistor.
[3 marks]Draw and explain seven segment display.
[4 marks]Compare BJT with FET and explain D MOSFET.
[7 marks]